Toolpack:Creating an MTP3 Linkset A
From TBwiki
(Difference between revisions)
| Line 13: | Line 13: | ||
* Select an '''originating point code''' (OPC) | * Select an '''originating point code''' (OPC) | ||
* Select an '''adjacent point code''' | * Select an '''adjacent point code''' | ||
| − | * Make sure the ''' | + | * Make sure the '''desired state''' is set to '''Active''' |
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 12:12, 4 August 2010
Now that you have created an MTP3 network, you are ready to create an MTP3 linkset. This can be done through the MTP3 network configuration window. A linkset is used to logically combine multiple MTP3 links going to the same DPC into a single entity. One linkset could be the links between a point code identifying the Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment.
To create an MTP3 linkset:
1- Click Create New Mtp3 Linkset in the MTP3 Network configuration panel
2- Configure the new linkset:
- Enter a name for the linkset
- Select an originating point code (OPC)
- Select an adjacent point code
- Make sure the desired state is set to Active
- Click Create
3- Verify that the "Mtp3Linkset was successfully created" message appears
