Toolpack:Creating an SCCP Route A
From TBwiki
(Difference between revisions)
| Line 23: | Line 23: | ||
[[Image:Toolpack_v2.5_SCCP_Route_Created.png]] | [[Image:Toolpack_v2.5_SCCP_Route_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Protocol Variant|Protocol Variant]] | ||
| + | * [[Parameter: Replicant Mode|Replicant Mode]] | ||
| + | * [[Parameter: SLS Mask|SLS Mask]] (For ANSI and TELCORDIA variants only) | ||
| + | * [[Parameter: Destination Point Code|Destination Point Code]] | ||
Revision as of 12:51, 5 August 2010
Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).
To Create an SCCP Route:
1- Click Create new Sccp Route in the SCCP LSAP configuration window
2- Configure the new SCCP Route:
- Choose a name for the new route
- Select a protocol variant
- Select a replicant mode
- Select an SLS mask (this is only for ANSI and TELCORDIA protocol variants)
- Select a destination point code (DPC)
- Click Create
3- Verify that the "SccpRoute was successfully created" message appears
List of Parameters
- Name
- Protocol Variant
- Replicant Mode
- SLS Mask (For ANSI and TELCORDIA variants only)
- Destination Point Code
