Toolpack:Creating an M2PA SAP A
From TBwiki
(Difference between revisions)
| Line 30: | Line 30: | ||
[[Image:Toolpack_v2.5_M2PA_SAP_IP_Interface.png]] | [[Image:Toolpack_v2.5_M2PA_SAP_IP_Interface.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: SCTP Source Port|SCTP Source Port]] | ||
Revision as of 15:14, 6 August 2010
Now that you have created an M2PA configuration, you must create a new M2PA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create a new M2PA SAP:
1- Select M2PA from the navigation panel
2- Click Create new M2pa Sap
3- Configure the new M2PA SAP:
- Enter a name for the SAP
- Enter an SCTP source port for the SAP
- Click Create
4- Verify that the "M2pa Sap was successfully created" message appears
5- Associate IP interfaces
- Select an IP interface from the list in the information panel
- Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.
