Toolpack:Creating the M2UA Configuration A
From TBwiki
(Difference between revisions)
| Line 20: | Line 20: | ||
[[Image:Toolpack_v2.5_M2UA_Created.png]] | [[Image:Toolpack_v2.5_M2UA_Created.png]] | ||
| + | |||
| + | |||
| + | ==Lit of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
Revision as of 16:24, 6 August 2010
To create your M2UA system, you must create a new M2UA configuration.
The M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.
To create an M2UA configuration:
1- Click M2UA in the navigation panel
2- Create the M2UA configuration:
- Enter a name for the M2UA service
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
