Toolpack:Creating a CAS R2 NAP A
From TBwiki
(Difference between revisions)
| Line 40: | Line 40: | ||
[[Image:Toolpack_v2.5_NAP_ISUP_Created.png]] | [[Image:Toolpack_v2.5_NAP_ISUP_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
Revision as of 13:18, 10 August 2010
Now that you have created a CAS R2 stack, you must create a network access point, in order to finish configuring your system. A Network Access Point (NAP) represents the entry point to another network or destination peer.
To create a network access point (NAP):
1- Click NAP in the navigation panel
2- Click Create New NAP
3- Configure the new NAP:
- Enter a name for the NAP
- Select a user-created profile, if not, select default
- Click Create
4- Verify that the NAP was successfully created message appears
5- Associate a CASR2 stack with the NAP:
- Select an interface (the newly-created CASR2 stack)
- Click the "<<" button to add the interface to the list
- Click Save
6- Verify that the "NAP was successfully updated" message appears
