Toolpack:Creating an SCCP Userpart A
| Line 1: | Line 1: | ||
| − | Now that you have configured an [[SCCP]] network, you must create a new SCCP user part | + | Now that you have configured an [[SCCP]] network: |
| + | |||
| + | 1) If you are using SCCP to perform GTT routing/translation in standalone mode, then skip this step (do not create SCCP user part). | ||
| + | 2) If you are using a TCAP, you must create a new SCCP user part, so that you can bind the SCCP and TCAP later on. | ||
The user part is the container for the multiple SCCP interfaces. One user part is required for each protocol variant. | The user part is the container for the multiple SCCP interfaces. One user part is required for each protocol variant. | ||
Revision as of 11:54, 1 May 2012
Now that you have configured an SCCP network:
1) If you are using SCCP to perform GTT routing/translation in standalone mode, then skip this step (do not create SCCP user part). 2) If you are using a TCAP, you must create a new SCCP user part, so that you can bind the SCCP and TCAP later on.
The user part is the container for the multiple SCCP interfaces. One user part is required for each protocol variant. Multiple SCCP user parts can be instantiated within a single SCCP protocol layer. This allows a user application to interface with multiple SS7 SCCP protocol variants at the same time. Only one SCCP user part is required for a specific variant as it can be assigned to multiple SCCP networks.
A user part can easily be seen as a protocol variant that a host application wants to use on the SS7 network.
To create an SCCP user part:
1- Click Create New SCCP User Part to access the SCCP configuration window
2- Configure the new SCCP user part
- Enter a name for the user part
- Enter a sub-system number
- Select the first concerned point code
- Select the second concerned point code
- Click Create
3- Verify that the "SCCP Userpart was successfully created" message appears
