Parameter: Call Control
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) (Nicole: Added the description for each value of the call control) |
|||
| Line 1: | Line 1: | ||
The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter can take on the following values: | The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter can take on the following values: | ||
| − | * Incoming | + | * Incoming:Circuits are always controlled by the remote end. Calls won't be sent to these Circuits. |
| − | * Outgoing | + | * Outgoing:Circuits are always controlled by TMG. Inbound Calls from these Circuits will be rejected. |
| − | * Bothway | + | * Bothway: Circuits work for both inbound and outbound calls. |
| − | * Controlled | + | * Controlled: Same as Incoming |
| − | * Controlling | + | * Controlling: Same as Outgoing |
[[Category:Parameters]] | [[Category:Parameters]] | ||
Revision as of 11:25, 21 December 2015
The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter can take on the following values:
- Incoming:Circuits are always controlled by the remote end. Calls won't be sent to these Circuits.
- Outgoing:Circuits are always controlled by TMG. Inbound Calls from these Circuits will be rejected.
- Bothway: Circuits work for both inbound and outbound calls.
- Controlled: Same as Incoming
- Controlling: Same as Outgoing
