TMG5800 Installation Guide

Revision as of 17:29, 23 September 2010 (view source) Allyntree (Talk | contribs) (→Further Reading) ← Older edit		Revision as of 17:29, 23 September 2010 (view source) Allyntree (Talk | contribs) (→Backdoor Tools) Newer edit →
Line 83:		Line 83:
	* [[Stream Server Audio Packets to Wave File]]		* [[Stream Server Audio Packets to Wave File]]
	* [[tbsigtrace signalling traces]]		* [[tbsigtrace signalling traces]]
		+	<br/><br/>
	==Further Reading==		==Further Reading==

---

Revision as of 17:29, 23 September 2010

NOTE! THIS PAGE IS UNDER CONSTRUCTION!

This guide describes the installation and setup of the Tmedia 5800 telecom platform and its connections to voice, and IP networks.

Contents 1 Introduction 1.1 Installation Overview 1.2 Installation Prerequisites 1.3 Preventing Electrostatic Discharge Damage 2 Equipment Connections 2.1 Package Contents 2.2 Rack Mounting the TMG5800 2.3 Connecting to the TMedia Management Interface 2.4 Connecting to the VoIP Network 2.5 Connecting to the PSTN 2.6 Powering Up 2.7 Powering Down 3 Initial System Configuration 4 System Upgrades 4.1 Installing a New License 5 Troubleshooting Tools 5.1 Connecting to the Serial Port of the TMG5800 5.2 Configuring the Terminal Emulator Application 5.3 Reporting a Problem 5.4 Setup Information 5.5 Tbdebug Dump Files 5.6 Application Logs 5.7 Backdoor Tools 6 Further Reading

Introduction

Installation Overview

Installation Prerequisites

Preventing Electrostatic Discharge Damage

Equipment Connections

Package Contents

At the time of purchase, the following items are included in the TMG5800 product bundle:

1. TMG5800
2. TMG5800 Quick Installation Guide

Rack Mounting the TMG5800

• Prerequisites
• Vertical Placement of the TMG5800
• Mounting the TMG5800

Connecting to the TMedia Management Interface

• Prerequisites
• Interconnections

Connecting to the VoIP Network

• Prerequisites
• Interconnections

Connecting to the PSTN

• Prerequisites
• RJ48 Interface (T1/E1/J1)
• SCSI Interface (T1/E1/J1)
• Dual BNC Interface (DS3)
• Optical Interface (OC3/STM-1)

Powering Up

• Prerequisites
• Connecting to AC Power
• Connecting to DC Power
• Verifying the LED Status Indications

Powering Down

Initial System Configuration

1. Configuring the TMG5800
2. Setting the Time Zone
3. Configuring the Toolpack Using Web Portal
4. Changing the TMG5800 Host IP
5. Changing VoIP Interface Addresses
6. Changing Passwords

System Upgrades

Installing a New License

Troubleshooting Tools

Connecting to the Serial Port of the TMG5800

Configuring the Terminal Emulator Application

Reporting a Problem

Setup Information

Tbdebug Dump Files

Application Logs

Backdoor Tools

• tbx_cli_tools_remote
• Line/Trunk Status (Tbshowls)
• VoIP Traffic Capture
• Wireshark
• Tbstreamlisten
• Stream Server Audio Packets to Wave File
• tbsigtrace signalling traces

Further Reading

Now that you have successfully installed your TMG5800 device, the following articles may be of interest to you:

• Web Portal Configuration Tool