Configuring IP Interfaces
From TBwiki
(Difference between revisions)
(Created page with 'The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following: *IP Address *Netmask *Gateway == To configure a VoIP0 or VoIP1 port == '''1. Select …') |
(→To configure a VoIP0 or VoIP1 port) |
||
Line 9: | Line 9: | ||
'''1. Select IP Interfaces from the navigation panel.''' | '''1. Select IP Interfaces from the navigation panel.''' | ||
− | + | [[Image:Toolpack_v2.5_Navigation_Panel_IP_Interfaces.png]] | |
− | + | '''2. Click 'Edit' from the IP Interfaces Information panel.''' | |
− | + | [[Image:Configuring IP Interfaces V2.3 1.jpg|600px]] | |
− | + | '''3. Enter an IP address, a Netmask, and a gateway address.''' | |
* | * | ||
Line 21: | Line 21: | ||
''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets'' | ''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets'' | ||
− | + | [[Image:Configuring IP Interfaces V2.3 2.jpg|600px]] | |
− | + | '''4. The changes are displayed in the IP interfaces information panel.''' | |
− | + | [[Image:Configuring IP Interfaces V2.3 3.jpg|600px]] | |
'''Note''': To apply the IP configuration change, activate the current configuration, and then reboot the adapter. | '''Note''': To apply the IP configuration change, activate the current configuration, and then reboot the adapter. |
Revision as of 15:57, 6 February 2011
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel.
2. Click 'Edit' from the IP Interfaces Information panel.
3. Enter an IP address, a Netmask, and a gateway address.
Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets
4. The changes are displayed in the IP interfaces information panel.
Note: To apply the IP configuration change, activate the current configuration, and then reboot the adapter.