Configuring IP Interfaces
From TBwiki
(Difference between revisions)
(→List of Parameters) |
|||
| Line 47: | Line 47: | ||
* [[Parameter: Use DHCP|Use DHCP]] | * [[Parameter: Use DHCP|Use DHCP]] | ||
* [[Parameter: IP Address|IP Address]] | * [[Parameter: IP Address|IP Address]] | ||
| − | * [[Parameter: | + | * [[Parameter: Netmask|Netmask]] |
* [[Parameter: Gateway|Gateway]] | * [[Parameter: Gateway|Gateway]] | ||
Revision as of 16:20, 6 February 2011
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Click 'Edit' from the IP Interfaces Information panel:
3. Configure the port:
- Indicate whether or not to use DHCP on this port
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets
4. The changes are displayed in the IP interfaces information panel:
IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:
