Toolpack:Creating the M2UA Configuration A
From TBwiki
(Difference between revisions)
(→Lit of Parameters) |
|||
| Line 22: | Line 22: | ||
| − | == | + | ==List of Parameters== |
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
Revision as of 19:39, 17 July 2011
To create your M2UA system, you must create a new M2UA configuration.
M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.
To create an M2UA configuration:
1- Click M2UA in the navigation panel
2- Create the M2UA configuration:
- Enter a name for the M2UA service
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
