Toolpack:Configuring RADIUS A
From TBwiki
(Difference between revisions)
(Created RADIUS configuration page for Toolpack v2.5 or lesser) |
m (Added borders) |
||
| Line 3: | Line 3: | ||
1- Select '''Gateway -> Configurations''' from the navigation panel. | 1- Select '''Gateway -> Configurations''' from the navigation panel. | ||
| − | [[Image:RADIUS_v2_5_gw_menu_configurations.png]] | + | [[Image:RADIUS_v2_5_gw_menu_configurations.png|border]] |
2- Verify that the box '''Use CDR behavior''' is checked. | 2- Verify that the box '''Use CDR behavior''' is checked. | ||
| − | [[Image:RADIUS_v2_5_gw_cdr_check.png]] | + | [[Image:RADIUS_v2_5_gw_cdr_check.png|border]] |
| Line 16: | Line 16: | ||
* Click '''Save''' to save your changes. | * Click '''Save''' to save your changes. | ||
| − | [[Image:RADIUS_v2_5_gw_cdr_configuration.png]] | + | [[Image:RADIUS_v2_5_gw_cdr_configuration.png|border]] |
4- Verify that the '''Gateway configuration was successfully updated.''' message appears. | 4- Verify that the '''Gateway configuration was successfully updated.''' message appears. | ||
| − | [[Image:RADIUS_v2_5_gw_cfg_success.png]] | + | [[Image:RADIUS_v2_5_gw_cfg_success.png|border]] |
Revision as of 16:06, 18 January 2012
This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier.
1- Select Gateway -> Configurations from the navigation panel.
2- Verify that the box Use CDR behavior is checked.
3- Configure the CDR behavior in the CDR Options section:
- Select Radius CDR in the CDR Mode combo box.
- In the Radius server parameters section, set the Radius server address and port and Server secret fields.
- Click Save to save your changes.
4- Verify that the Gateway configuration was successfully updated. message appears.
