Toolpack:Configuring RADIUS A

From TBwiki

(Difference between revisions)

Revision as of 17:26, 14 June 2012

This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier.

1- Select Gateway -> Configurations from the navigation panel.

2- Verify that the box Use CDR behavior is checked.

3- Configure the CDR behavior in the CDR Options section:

Select Radius CDR in the CDR Mode combo box.
In the Radius server parameters section, set the Radius server address and port and Server secret fields.
Click Save to save your changes.

4- Verify that the Gateway configuration was successfully updated. message appears.

@@ Line 1: / Line 1: @@
+=== '''''Applies to version(s): v2.5, v2.6.''''' ===
+{{DISPLAYTITLE:Toolpack: Navigating the Web Portal}}
 This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier.