Toolpack:Creating an SCCP LSAP A
From TBwiki
(Difference between revisions)
m (moved Toolpack v2.5:Creating an SCCP LSAP to Toolpack:Creating an SCCP LSAP A: New naming convention) |
|||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.5, v2.6.''''' === | === '''''Applies to version(s): v2.5, v2.6.''''' === | ||
| − | {{DISPLAYTITLE: | + | {{DISPLAYTITLE:Creating an SCCP LSAP}} |
Now that you have created an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | Now that you have created an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | ||
Revision as of 13:39, 9 July 2012
Applies to version(s): v2.5, v2.6.
Now that you have created an SCCP network, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Click Create New SCCP LSAP in the SCCP network configuration window
2- Configure the new SCCP LSAP:
- Enter a Name for the LSAP
- Click Save
3- Verify that the "SccpLsap was successfully created" message appears
4- Next Step: Create an SCCP Route
List of Parameters
| Previous | Next |
|---|---|
| Create an SCCP Userpart | Create an SCCP Route |
