Toolpack:Creating the M2UA Configuration A
From TBwiki
(Difference between revisions)
m (moved Toolpack v2.5:Creating the M2UA Configuration to Toolpack:Creating the M2UA Configuration A: New naming convention) |
|||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.5, v2.6.''''' === | === '''''Applies to version(s): v2.5, v2.6.''''' === | ||
| − | {{DISPLAYTITLE: | + | {{DISPLAYTITLE:Creating the M2UA Configuration}} |
To create your [[M2UA]] system, you must create a new M2UA configuration. | To create your [[M2UA]] system, you must create a new M2UA configuration. | ||
Latest revision as of 13:45, 9 July 2012
Applies to version(s): v2.5, v2.6.
To create your M2UA system, you must create a new M2UA configuration.
M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.
To create an M2UA configuration:
1- Click M2UA in the navigation panel
2- Create the M2UA configuration:
- Enter a name for the M2UA service
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
