Toolpack:Modifying ISUP Userpart for SPIROU A
From TBwiki
(Difference between revisions)
(First version of the page to configure ISUP userpart for SPIROU) |
(Adding title to the page) |
||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.6, v2.7.''''' === | ||
| + | {{DISPLAYTITLE:Modifying ISUP Userpart for SPIROU}} | ||
| + | |||
This section assumes: | This section assumes: | ||
* '''SS7 ISUP is already configured''' | * '''SS7 ISUP is already configured''' | ||
Revision as of 09:12, 13 December 2012
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
1- Select SS7-->ISUP from the navigation panel
2- Click on the Edit button for the ISUP stack you want to configure
3- In the Editing Userparts section, click on the ISUP userpart you want to configure
4- Select SPIROU in the Protocol Variant drop-down menu
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
6- Click the Save button
7- Verify that the "IsupUserpart was successfully updated" message is displayed
