Toolpack:Modifying ISUP Stack for SPIROU A

Revision as of 15:05, 14 December 2012

Applies to version(s): v2.6, v2.7.

This section assumes:

• SS7 ISUP is already configured

Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the ISUP stacks in your current configuration..

1- Select SS7-->ISUP from the navigation panel

2- Click on the Edit button for the ISUP stack you want to configure

2- Expand the Advanced Parameters section and check the following parameters

• No confusion must be chosen

3- Click the Save button

4- Verify that the "IsupStack was successfully updated" message is displayed

List of Parameters

• Isup Stack Options