Toolpack:Enabling RADIUS B
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.7) |
(→Applies to version(s): v2.7) |
||
| Line 25: | Line 25: | ||
* Click '''Save''' to save your changes. | * Click '''Save''' to save your changes. | ||
| − | [[Image:Cdr_2|border]] | + | [[Image:Cdr_2.png|border]] |
4- Verify that the '''Gateway configuration was successfully updated.''' message appears. | 4- Verify that the '''Gateway configuration was successfully updated.''' message appears. | ||
[[Image:RADIUS_v2_5_gw_cfg_success.png|border]] | [[Image:RADIUS_v2_5_gw_cfg_success.png|border]] | ||
Revision as of 12:06, 15 July 2013
Applies to version(s): v2.7
This page describes how to enable and configure a TMG system to capture CDRs, using a RADIUS server.
Enabling RADIUS
1- Select Gateway from the navigation panel.
2- Verify that the box Use CDR behavior is checked.
3- Configure the CDR behavior in the CDR Options section:
- Enable periodic CDR update will add one entry in the CDR per Periodic CDR update time, in minutes.
- Select the CDR Mode:
- Text CDR only: Will store the CDRs in a flat file. See Text CDR
- RADIUS CDR only: Will send the CDR to an external RADIUS Server. See Radius CDR
- Text and RADIUS CDR: Will store the CDRs in a flat file and send the CDR to an external RADIUS Server.
- RADIUS CDR with Text CDR Fallback: Will send the CDR to an external RADIUS Server and if the RADIUS server cannot handle the load of CDRs, they will be stored in a flat file.
- Click Save to save your changes.
4- Verify that the Gateway configuration was successfully updated. message appears.
