Toolpack:Creating an M3UA Configuration SGP B
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) (Initial the page) |
Nicole Tan (Talk | contribs) (Modified the page from IPSP to SGP) |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.7.''''' === | === '''''Applies to version(s): v2.7.''''' === | ||
| − | {{DISPLAYTITLE:Creating an M3UA Configuration | + | {{DISPLAYTITLE:Creating an M3UA Configuration - SGP}} |
To set up your M3UA system on an IP server process (IPSP), you must first create a new M3UA configuration. | To set up your M3UA system on an IP server process (IPSP), you must first create a new M3UA configuration. | ||
In this configuration the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer. This system is typically set up on two IP signaling points. | In this configuration the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer. This system is typically set up on two IP signaling points. | ||
| Line 11: | Line 11: | ||
[[Image:M3ua_0.png]] | [[Image:M3ua_0.png]] | ||
| − | 2- Configure the M3UA service for | + | 2- Configure the M3UA service for SGP: |
* Enter a '''name''' for the configuration | * Enter a '''name''' for the configuration | ||
| − | * Select ''' | + | * Select '''Signaling Gateway Process (SGP)''' as the node type |
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 09:15, 28 May 2014
Applies to version(s): v2.7.
To set up your M3UA system on an IP server process (IPSP), you must first create a new M3UA configuration. In this configuration the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer. This system is typically set up on two IP signaling points.
To create an M3UA configuration on IPSP:
1- Click M3UA in the navigation panel:
2- Configure the M3UA service for SGP:
- Enter a name for the configuration
- Select Signaling Gateway Process (SGP) as the node type
- Click Create
3- Verify that the "M3ua Cfg was successfully created" message appears
