Toolpack:Creating an M3UA User Part (SGP) A
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) |
(Remove IMPORTANT notice and remove reference to 2.5, 2.6.) |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): | + | === '''''Applies to version(s): v2.7''''' === |
{{DISPLAYTITLE:Creating an M3UA User Part (SGP)}} | {{DISPLAYTITLE:Creating an M3UA User Part (SGP)}} | ||
Now that you have created an M3UA network, you must create a new M3UA user part. | Now that you have created an M3UA network, you must create a new M3UA user part. | ||
| Line 13: | Line 13: | ||
* Enter a '''name''' for the user part | * Enter a '''name''' for the user part | ||
| − | + | * For a system set up on a '''Signaling Gateway''', you need to connect this entity to a '''MTP3 network''': Select an '''MTP3 network''' | |
| − | + | ||
| − | + | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 21:52, 2 July 2014
Applies to version(s): v2.7
Now that you have created an M3UA network, you must create a new M3UA user part.
To create an M3UA user part:
1- Click Create New M3ua Userpart in the M3UA network configuration window
2- Configure the new M3UA user part:
- Enter a name for the user part
- For a system set up on a Signaling Gateway, you need to connect this entity to a MTP3 network: Select an MTP3 network
- Click Create
3- Verify that the "M3ua Userpart was successfully created" message appears
List of Parameters
- Name
- MTP3 Network (only for SG)
