Toolpack:Database Backup C
From TBwiki
(Difference between revisions)
(New Article) |
m (→Applies to version(s): v2.8.) |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.8.''''' === | === '''''Applies to version(s): v2.8.''''' === | ||
{{DISPLAYTITLE:Database Backup}} | {{DISPLAYTITLE:Database Backup}} | ||
| − | The “Backups” menu enables you to create a backup of the configuration | + | The “Backups” menu enables you to create a backup of the configuration. This will allow you to restore data or to install the same configuration on another unit. |
<br>After carrying out system modifications, it is STRONGLY recommended that you back up the MYSQL database used by Toolpack. | <br>After carrying out system modifications, it is STRONGLY recommended that you back up the MYSQL database used by Toolpack. | ||
<br>Below are the steps to do so: | <br>Below are the steps to do so: | ||
Revision as of 09:25, 31 July 2014
Applies to version(s): v2.8.
The “Backups” menu enables you to create a backup of the configuration. This will allow you to restore data or to install the same configuration on another unit.
After carrying out system modifications, it is STRONGLY recommended that you back up the MYSQL database used by Toolpack.
Below are the steps to do so:
1- Click Backups in the navigation panel
2- Click Create (In the Create New Database Backup section)
3- Verify that the Database backup dump was successfully started. Refresh this page when it is done message appears.
- Refresh your Internet browser page
4- Verify that the new backup appears in the Database Backup List
