Toolpack:Configuring VoIP Interfaces C
From TBwiki
(Difference between revisions)
(→To configure a VoIP0 or VoIP1 port) |
(→To configure a VoIP0 or VoIP1 port) |
||
| Line 22: | Line 22: | ||
<br> 3. Configure the IP port: | <br> 3. Configure the IP port: | ||
| − | *Indicate whether or not to use '''DHCP''' on this port | + | *Enter a name for the interface |
| + | *Select a service to use for the IP inteface | ||
| + | *Indicate whether or not to use '''DHCP''' (dynamic IP) on this port | ||
*Enter an '''IP address''' | *Enter an '''IP address''' | ||
*Enter a '''Netmask''' | *Enter a '''Netmask''' | ||
Revision as of 09:36, 25 August 2014
Applies to version(s): v2.8.
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Click Edit from the IP Interfaces Information panel:
3. Configure the IP port:
- Enter a name for the interface
- Select a service to use for the IP inteface
- Indicate whether or not to use DHCP (dynamic IP) on this port
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.
4. The changes are displayed in the IP interfaces information panel:
5. Activate the configuration
Systems -> Edit -> Activate
6. Reboot the adapter (will drop active calls)
Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter
It will take about 1.5 minutes to restart the unit.
Note: in a 1+1 system, both units must be restarted.
