Toolpack:Configuring VoIP Interfaces C
From TBwiki
(Difference between revisions)
(→To configure a VoIP0 or VoIP1 port) |
(→To configure a VoIP0 or VoIP1 port) |
||
| Line 16: | Line 16: | ||
[[Image:Create Voip Interface_0.png]] | [[Image:Create Voip Interface_0.png]] | ||
| − | <br> 2. | + | <br> 2. Select the '''IP Interfaces''' tab and click '''Create New IP Interface''' from the IP Interfaces Information panel: |
[[Image:Create Voip Interface_1.png]] | [[Image:Create Voip Interface_1.png]] | ||
Revision as of 08:43, 26 August 2014
Applies to version(s): v2.8.
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Select the IP Interfaces tab and click Create New IP Interface from the IP Interfaces Information panel:
3. Configure the IP port:
- Enter a name for the interface
- Select a service to use for the IP inteface
- Indicate whether or not to use DHCP (dynamic IP) on this port
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.
4. The changes are displayed in the IP interfaces information panel:
5. Activate the configuration
Systems -> Edit -> Activate
6. Reboot the adapter (will drop active calls)
Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter
It will take about 1.5 minutes to restart the unit.
Note: in a 1+1 system, both units must be restarted.
