Toolpack:Creating an MTP3 Linkset B

Revision as of 08:12, 16 September 2014

Applies to version(s): v2.5, v2.6., v2.7

Now that you have created an MTP3 network, you are ready to create an MTP3 linkset. This can be done through the MTP3 network configuration window. A linkset is used to logically combine multiple MTP3 links going to the same DPC into a single entity. One linkset could be the links between a point code identifying the Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment.

To create an MTP3 linkset:

1- Click MTP3 in the navigation pane.

1- Click Create New Mtp3 Linkset in the MTP3 Network configuration panel

2- Configure the new linkset:

• Enter a name for the linkset
• Select an origin point code (OPC)
• Select an adjacent point code
• Make sure the desired state is set to Active
• Click Create

3- Verify that the "Mtp3Linkset was successfully created" message appears

List of Parameters

• Name
• Origin Point Code
• Adjacent Point Code
• Desired State