Toolpack:Creating an MTP3 Route B
From TBwiki
(Difference between revisions)
(New 2.8 article: In process) |
(New 2.8 article) |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2. | + | === '''''Applies to version(s): v2.8''''' === |
{{DISPLAYTITLE:Creating an MTP3 Route}} | {{DISPLAYTITLE:Creating an MTP3 Route}} | ||
| − | [[MTP3 Layer|MTP3]] routes are | + | [[MTP3 Layer|MTP3]] routes are designed to route traffic from previously created point codes using linksets. |
| − | You require | + | You require one route per point code in your system. This means one route per DPC (SSP and STP) and one route per source point code (OPC). |
To create an MTP3 route: | To create an MTP3 route: | ||
| − | 1- Click '''Create New Mtp3 Route''' in the MTP3 network configuration window: | + | 1- Click '''MTP3''' in the navigation pane. |
| + | |||
| + | [[Image:Mtp3_0_A.png]] | ||
| + | |||
| + | |||
| + | 2- Click '''Create New Mtp3 Route''' in the MTP3 network configuration window: | ||
| + | |||
| + | [[Image:Create_MTP3_Route_0.png]] | ||
| − | |||
2- Configure the new MTP3 route: | 2- Configure the new MTP3 route: | ||
| Line 21: | Line 27: | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | [[Image: | + | [[Image:Create_MTP3_Route_1.png]] |
| + | |||
3- Verify that the '''"Mtp3Route was successfully created"''' message appears | 3- Verify that the '''"Mtp3Route was successfully created"''' message appears | ||
| − | [[Image: | + | [[Image:Create_MTP3_Route_2.png]] |
| + | |||
4- Associate the newly created route with a linkset: | 4- Associate the newly created route with a linkset: | ||
| Line 32: | Line 40: | ||
* Click the '''"<<"''' button to associate the linkset with the newly created route | * Click the '''"<<"''' button to associate the linkset with the newly created route | ||
| − | [[Image: | + | [[Image:Create_MTP3_Route_3.png]] |
Revision as of 10:02, 16 September 2014
Applies to version(s): v2.8
MTP3 routes are designed to route traffic from previously created point codes using linksets.
You require one route per point code in your system. This means one route per DPC (SSP and STP) and one route per source point code (OPC).
To create an MTP3 route:
1- Click MTP3 in the navigation pane.
2- Click Create New Mtp3 Route in the MTP3 network configuration window:
2- Configure the new MTP3 route:
- Enter a name for the route
- Select a point code for the route
- Select a restart procedure
- Select a point type
- Check the Route to Adjacent box, if this route is directed to an adjacent network
- Click Create
3- Verify that the "Mtp3Route was successfully created" message appears
4- Associate the newly created route with a linkset:
- Select a linkset from the list provided at the bottom of the route configuration window
- Click the "<<" button to associate the linkset with the newly created route
