Toolpack:Creating an ISUP User Part B
(New 2.8 article) |
(→Applies to version(s): v2.8.) |
||
Line 3: | Line 3: | ||
Once you have created your ISUP network, you must create a new ISUP user part. | Once you have created your ISUP network, you must create a new ISUP user part. | ||
− | The user part is the container for the multiple [[ISUP]] interfaces. One user part is required for each protocol variant. | + | The user part is the container for the multiple [[ISUP]] interfaces. One user part is required for each protocol variant. A user part can be seen as a protocol variant that a host application wants to use on the SS7 network. |
− | Multiple ISUP user parts can be instantiated within a single ISUP protocol layer. This allows a user application to interface with multiple [[SS7]] ISUP protocol variants at the same time. | + | Multiple ISUP user parts can be instantiated within a single ISUP protocol layer. This allows a user application to interface with multiple [[SS7]] ISUP protocol variants at the same time. In addition, only one ISUP user part is required for a specific variant as it can be assigned to multiple ISUP networks. |
− | |||
To create an ISUP user part: | To create an ISUP user part: | ||
Line 41: | Line 40: | ||
[[Image:Create_ISUP_Userpart_2.png]] | [[Image:Create_ISUP_Userpart_2.png]] | ||
− | |||
==List of Parameters== | ==List of Parameters== |
Revision as of 10:55, 17 September 2014
Applies to version(s): v2.8.
Once you have created your ISUP network, you must create a new ISUP user part.
The user part is the container for the multiple ISUP interfaces. One user part is required for each protocol variant. A user part can be seen as a protocol variant that a host application wants to use on the SS7 network.
Multiple ISUP user parts can be instantiated within a single ISUP protocol layer. This allows a user application to interface with multiple SS7 ISUP protocol variants at the same time. In addition, only one ISUP user part is required for a specific variant as it can be assigned to multiple ISUP networks.
To create an ISUP user part:
1- Click ISUP in the navigation pane.
2- Select the ISUP stack
3- Click Create New Isup Userpart in the ISUP stack configuration window:
4- Configure the new ISUP user part:
- Enter a name for the user part
- Select a protocol variant (depending on location)
- Select an MTP3 sub service field (the same that was previously set for MTP3)
- Select an address indicator type
- Select a Numbering Plan
- Click Create
5- Verify that the "IsupUserpart was successfully created" message appears