Toolpack:Creating the M2PA Configuration c
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→Applies to version(s): v2.8.) |
||
| Line 8: | Line 8: | ||
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
| + | |||
2- Configure the SCTP service | 2- Configure the SCTP service | ||
| Line 13: | Line 14: | ||
* Make sure the box labelled '''Enabled''' is '''checked''' | * Make sure the box labelled '''Enabled''' is '''checked''' | ||
* Enter a '''name''' for the SCTP service | * Enter a '''name''' for the SCTP service | ||
| − | |||
| − | |||
| − | |||
* Click '''Create''' | * Click '''Create''' | ||
[[Image:CreateM2pa_1.png]] | [[Image:CreateM2pa_1.png]] | ||
| − | |||
| − | + | 3- Verify that the '''"M2pa Cfg was successfully created"''' message appears | |
| + | [[Image:CreateM2pa_2.png]] | ||
==List of Parameter== | ==List of Parameter== | ||
Revision as of 09:39, 18 September 2014
Applies to version(s): v2.8.
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
To edit your system's SCTP configuration:
1- Select SCTP from the navigation panel
2- Configure the SCTP service
- Make sure the box labelled Enabled is checked
- Enter a name for the SCTP service
- Click Create
3- Verify that the "M2pa Cfg was successfully created" message appears
