Toolpack:Adding M2PA Links B
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8) |
(→Applies to version(s): v2.8) |
||
| Line 11: | Line 11: | ||
| − | 2- Select an M2PA | + | 2- Select an M2PA SAP: |
[[Image:SelectM2paLink_0.png]] | [[Image:SelectM2paLink_0.png]] | ||
Revision as of 10:26, 18 September 2014
Applies to version(s): v2.8
After you create an M2PA service access point (SAP), you must create a new M2PA link. This is done from the M2PA SAP configuration window. To create an M2PA link:
1- Click M2PA in the navigation panel:
2- Select an M2PA SAP:
3- Click Create new M2pa link in the M2PA SAP configuration window:
4- Configure the new link:
- Enter a name for the link
- Select a protocol type:
- Set other features, as needed:
- Number of SCTP Streams
- IP Header TOS
- Destination port (same value as the one configured on the destination side)
- Click Create
5- Enter a destination address in the appropriate box in the information panel:
- Click the "<<" button to add the destination address to the address list
6- Verify that the address has been added to the list, and that the "(your address) was successfully added" message appears (ex.: here the address is 190.0.0.0)
