Toolpack:Creating the M2PA Configuration B
From TBwiki
(Difference between revisions)
(→List of Parameter) |
|||
| Line 15: | Line 15: | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | [[Image: | + | [[Image:CreateM2pa_1_a.png]] |
3- Verify that the '''"M2ua Cfg was successfully created"''' message appears | 3- Verify that the '''"M2ua Cfg was successfully created"''' message appears | ||
Latest revision as of 11:57, 18 September 2014
Applies to version(s): v2.7.
To create an M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
