Toolpack:Creating an M3UA SAP (IPSP) B
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→Applies to version(s): v2.8) |
||
| Line 10: | Line 10: | ||
| − | 2 | + | 2- Click '''Create New M3ua Sap''' in the M3UA configuration panel |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
[[Image:Create_M3UA_SAP_0.png]] | [[Image:Create_M3UA_SAP_0.png]] | ||
| − | + | 3- Configure the new SAP: | |
* Enter a '''name''' for the SAP | * Enter a '''name''' for the SAP | ||
| Line 30: | Line 25: | ||
| − | + | 4- Verify that the '''"M3ua Sap was successfully created"''' message appears | |
[[Image:Toolpack_v2.5_M3UA_SAP_Created.png]] | [[Image:Toolpack_v2.5_M3UA_SAP_Created.png]] | ||
| − | + | 5- Associate an IP interface with the new SAP: | |
* Select an available '''IP interface''' | * Select an available '''IP interface''' | ||
| Line 41: | Line 36: | ||
[[Image:Create_M3UA_SAP_2.png]] | [[Image:Create_M3UA_SAP_2.png]] | ||
| − | |||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 10:40, 22 September 2014
Applies to version(s): v2.8
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click M3UA in the navigation panel:
2- Click Create New M3ua Sap in the M3UA configuration panel
3- Configure the new SAP:
- Enter a name for the SAP
- Select an SCTP adapter to use
- Select an SCTP source port
- Click Create
4- Verify that the "M3ua Sap was successfully created" message appears
5- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
