Toolpack:Creating an M3UA SAP (IPSP) B
From TBwiki
(Difference between revisions)
m |
|||
| Line 27: | Line 27: | ||
4- Verify that the '''"M3ua Sap was successfully created"''' message appears | 4- Verify that the '''"M3ua Sap was successfully created"''' message appears | ||
| − | [[Image: | + | [[Image:Create_M3UA_SAP_2.png]] |
| Line 35: | Line 35: | ||
* Click the'''"<<"''' button to associate the interface with the SAP | * Click the'''"<<"''' button to associate the interface with the SAP | ||
| − | [[Image: | + | [[Image:Create_M3UA_SAP_3.png]] |
==List of Parameters== | ==List of Parameters== | ||
Revision as of 10:53, 22 September 2014
Applies to version(s): v2.8
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click M3UA in the navigation panel:
2- Click Create New M3ua Sap in the M3UA configuration panel
3- Configure the new SAP:
- Enter a name for the SAP
- Select an Unit to use
- Select an SCTP source port
- Click Create
4- Verify that the "M3ua Sap was successfully created" message appears
5- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
