Toolpack:Creating an SCCP Route B
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→Applies to version(s): v2.8) |
||
| Line 53: | Line 53: | ||
[[Image:Create_SCCP_Route_3.png]] | [[Image:Create_SCCP_Route_3.png]] | ||
| − | * '''Note: For each selected point codes, a valid SCCP route must | + | * '''Note: For each selected point codes, a valid SCCP route must exist'''. |
| − | + | ||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 12:36, 26 September 2014
Applies to version(s): v2.8
Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).
To Create an SCCP Route:
1- Select SCCP from the navigation panel
2- Select an SCCP Network
3- Select an SCCP LSAP
4- Click Create new Sccp Route in the SCCP LSAP configuration window
5- Configure the new SCCP Route:
- Choose a Name for the new route
- Select a Protocol Variant
- Select a Replication Mode (ANSI96 and TELCORDIA variants)
- Select an SLS Mask (ANSI and TELCORDIA protocol variants)
- Select a Destination Point Code for this route
- Click Create
6- Verify that the "SccpRoute was successfully created" message appears
7- Configure SCCP Route Backup Point Code
- Assign Backup Point Codes to use in case this route's DPC is not available.
- Note: For each selected point codes, a valid SCCP route must exist.
List of Parameters
- Name
- Protocol Variant
- Replication Mode
- SLS Mask (For ANSI and TELCORDIA variants only)
- Destination Point Code
