Toolpack:Modifying Profile for SPIROU B
From TBwiki
(Difference between revisions)
(2.8 Spirou article) |
|||
| Line 13: | Line 13: | ||
2- Select the profile you wish to configure | 2- Select the profile you wish to configure | ||
| − | [[Image: | + | [[Image:ModifyProfileSpirou_1.png]] |
| Line 22: | Line 22: | ||
* '''Max Forwards header handling''' must be set to Decrement and forward | * '''Max Forwards header handling''' must be set to Decrement and forward | ||
| − | [[Image: | + | [[Image:ModifyProfileSpirou_2.png]] |
| Line 30: | Line 30: | ||
* '''Hop Counter IE handling''' must be set to Decrement and forward | * '''Hop Counter IE handling''' must be set to Decrement and forward | ||
| − | [[Image: | + | [[Image:ModifyProfileSpirou_3.png]] |
| Line 37: | Line 37: | ||
* Click '''Save''' | * Click '''Save''' | ||
| − | [[Image: | + | [[Image:ModifyProfileSpirou_4.png]] |
6- Verify that the '''"Profile was successfully updated"''' message is displayed | 6- Verify that the '''"Profile was successfully updated"''' message is displayed | ||
| − | [[Image: | + | [[Image:ModifyProfileSpirou_5.png]] |
Revision as of 16:29, 14 November 2014
Applies to version(s): v2.8.
This articles assumes that SS7 ISUP is configured
Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all of the profiles in your current configuration..
1- Select Profiles from the navigation panel
2- Select the profile you wish to configure
3- Expand the SIP section and set the following parameter check boxes:
- Forward SS7 suspend/resume must be checked
- Forward SS7 CPG hold/retrieval must be checked
- Forward SIP hold type must be set to SS7 Suspend/Resume or SS7 Remote Hold/Retrieval
- Max Forwards header handling must be set to Decrement and forward
4- Expand the SS7 section and set the following parameter check boxes:
- Forward call suspend/resume must be checked
- Forward call CPG hold/retrieval must be checked
- Hop Counter IE handling must be set to Decrement and forward
5- Expand the SS7 or ISDN section and set the following parameter checkboxes:
- Information transfer capability must be set to Relay
- Click Save
6- Verify that the "Profile was successfully updated" message is displayed
