Toolpack:Modifying ISUP Userpart for SPIROU B
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8.) |
(→Applies to version(s): v2.8.) |
||
| Line 21: | Line 21: | ||
4- Select '''SPIROU''' in the '''Protocol Variant''' drop-down menu. | 4- Select '''SPIROU''' in the '''Protocol Variant''' drop-down menu. | ||
| − | [[Image: | + | [[Image:ModifyIsupUserPartForSpirou_1.png]] |
| Line 27: | Line 27: | ||
* Select this checkbox to make sure your configuraton is compliant with SPIROU. | * Select this checkbox to make sure your configuraton is compliant with SPIROU. | ||
| − | [[Image: | + | [[Image:ModifyIsupUserPartForSpirou_2.png]] |
| Line 33: | Line 33: | ||
* Set '''T6 Timer''' to a value between 60000 and 120000 ms (between 60 and 120 seconds) | * Set '''T6 Timer''' to a value between 60000 and 120000 ms (between 60 and 120 seconds) | ||
| − | [[Image: | + | [[Image:ModifyIsupUserPartForSpirou_3.png]] |
| Line 40: | Line 40: | ||
* Click '''Save''' | * Click '''Save''' | ||
| − | [[Image: | + | [[Image:ModifyIsupUserPartForSpirou_4.png]] |
8- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | 8- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | ||
| − | [[Image: | + | [[Image:ModifyIsupUserPartForSpirou_5.png]] |
==List of Parameters== | ==List of Parameters== | ||
Revision as of 11:47, 17 November 2014
Applies to version(s): v2.8.
This article assumes that SS7 ISUP is configured'.
1- Select ISUP from the navigation panel
2- Select the ISUP stack you wishto configure.
3- In the Editing Userparts section, select the ISUP userpart you to configure.
4- Select SPIROU in the Protocol Variant drop-down menu.
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
- Select this checkbox to make sure your configuraton is compliant with SPIROU.
6- Click Timers to expand the Timers section
- Set T6 Timer to a value between 60000 and 120000 ms (between 60 and 120 seconds)
7- Click Advanced Parameters to expand the Advanced Parameters section
- Uncheck the Allow group messages option
- Click Save
8- Verify that the "IsupUserpart was successfully updated" message is displayed
