Toolpack:Reset HostRole A
From TBwiki
(Difference between revisions)
(Reset host role article) |
|||
| Line 7: | Line 7: | ||
| − | 1- | + | 1- Click '''Hosts''' in the navigation panel. |
[[Image:HostRoleReset_0_A.png]] | [[Image:HostRoleReset_0_A.png]] | ||
Revision as of 12:28, 2 February 2015
Applies to version v2.8
If you need to change the internal IP addresses of a gateway, you must reset the units' host role settings.
To reset the host role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal Unit Role Selection page is displayed. (You may need to refresh your web page to see this)
