Toolpack:Creating a 1+1 Group B
From TBwiki
(Difference between revisions)
(→Applies to version v2.8) |
(Save -> Create) |
||
| Line 21: | Line 21: | ||
* Select the '''serial number''' of the 1+1 backup hardware device. | * Select the '''serial number''' of the 1+1 backup hardware device. | ||
* Set '''Auto switch-back''' to cause an automatic switch back to the original primary hardware device when it becomes available. If the field is clear (not checked), then a switch back to the original device will occur only after a manual reboot of the system. | * Set '''Auto switch-back''' to cause an automatic switch back to the original primary hardware device when it becomes available. If the field is clear (not checked), then a switch back to the original device will occur only after a manual reboot of the system. | ||
| − | * Click ''' | + | * Click '''Create''' |
[[Image:Create1and1Group_2_B.png]] | [[Image:Create1and1Group_2_B.png]] | ||
Revision as of 12:34, 1 June 2015
Applies to version v2.8
A 1+1 group indentifies the two Tmedia hardware devices that operate together to provide 1+1 backup protection. One device is identified as the primary hardware device, while the other device is identified as the backup hardware device. To create a 1+1 group, you must use the Tmedia Web Portal.
To create a 1+1 group:
1- Click 1+1 in the navigation panel
2- Click Create New 1+1 Group
3- Enter the serial numbers of the primary and 1+1 backup hardware devices.
- Provide a name for the 1+1 group.
- Select the serial number of the primary hardware device. (This field may already be filled.)
- Select the serial number of the 1+1 backup hardware device.
- Set Auto switch-back to cause an automatic switch back to the original primary hardware device when it becomes available. If the field is clear (not checked), then a switch back to the original device will occur only after a manual reboot of the system.
- Click Create
4- Verify that the newly added 1+1 group appears in the 1+1 Groups List
