Toolpack:Creating SS7 Point Codes C
From TBwiki
(Difference between revisions)
(Revised the introduction) |
(→Applies to version(s): v2.8.) |
||
| Line 3: | Line 3: | ||
Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next. | Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next. | ||
| − | To create SS7 originating (OPC) and destination (DPC) | + | To create SS7 originating point codes (OPC) and destination point codes (DPC): |
| − | + | ||
1- Click '''Point Codes''' in the navigation panel | 1- Click '''Point Codes''' in the navigation panel | ||
| Line 29: | Line 28: | ||
[[Image:PointCodes_3_A.png]] | [[Image:PointCodes_3_A.png]] | ||
| − | |||
==List of parameters== | ==List of parameters== | ||
Revision as of 10:06, 23 June 2015
Applies to version(s): v2.8.
Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next.
To create SS7 originating point codes (OPC) and destination point codes (DPC):
1- Click Point Codes in the navigation panel
2- Click Create New Point Code
3- Configure the new point code:
- Enter a name for the point code
- Select a point code type (select type-specific parameters)
- Select a point code length (14, 16, 24 bits)
- Enter a point code
- Click Create
In this example, an originating point code (OPC) is created.
4. Verify that the "PointCode was successfully created" message appears, and the new point code appears in the Point Codes list
