Toolpack:Creating an M3UA User Part (SGP) B
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8) |
(→List of Parameters) |
||
| Line 37: | Line 37: | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| + | |||
| + | |||
| + | ==Advanced Parameters== | ||
| + | |||
| + | * [[Parameter: MTP3 Primitive Timer|MTP3 Primitive Timer]] | ||
Revision as of 14:03, 26 June 2015
Applies to version(s): v2.8
After you create an M3UA network, you must create a new M3UA user part.
To create an M3UA user part:
1- Click M3UA in the navigation panel:
2- Select an M3ua Network:
3- Click Create New M3ua Userpart in the M3UA network configuration window
3- Configure the new M3UA user part:
- For a system set up on a Signaling Gateway, you need to connect this entity to a MTP3 network: Select an MTP3 network
- Note: the MTP3 network field is only shown for a SGP.
- Click Create
4- Verify that the "M3ua Userpart was successfully created" message appears
List of Parameters
