Toolpack:Configuring VoIP Interfaces C

From TBwiki

(Difference between revisions)

Revision as of 11:01, 22 July 2015

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

1. Select IP Interfaces from the navigation panel:

2. Select the IP Interfaces tab and click Create New IP Interface from the IP Interfaces Information panel:

3. Configure the IP port:

Enter a name for the interface
Select a service to use for the IP inteface
Select a Virtual port from which IP packets will exit.
Indicate whether or not to use dynamic IP will be used on this inteface. For example DHCP to automatically get an IP address for this port. (selecting this option removes the need to enter and IP address, Netmask, and Gateway)
Enter an IP address
Enter a Netmask
Enter a gateway address
Click Save

Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.

4. The changes are displayed in the IP interfaces information panel:

5. Activate the configuration

Systems -> Edit -> Activate

6. It is necessary to reboot the adapters if you are using the vlan from 3441 to 3450 only.

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

Note: in a 1+1 system, both units must be restarted.

@@ Line 18: / Line 18: @@
 <br> 2. Select the '''IP Interfaces''' tab and click '''Create New IP Interface''' from the IP Interfaces Information panel:
-[[Image:Create Voip_Interface_1.png]]
+[[Image:Create Voip_Interface_1a.png]]
 <br> 3. Configure the IP port: