Toolpack:Creating MTP2 Links B
From TBwiki
(Difference between revisions)
(→List of Parameters: Added parameter links for Timers, Advanced parameters and live states) |
(→List of Parameters) |
||
| Line 50: | Line 50: | ||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
| − | * [[Parameter: T1 Timer|T1 Timer]] | + | * [[Parameter: MTP2 T1 Timer|T1 Timer]] |
| − | * [[Parameter: T2 Timer|T2 Timer]] | + | * [[Parameter: MTP2 T2 Timer|T2 Timer]] |
| − | * [[Parameter: T3 Timer|T3 Timer]] | + | * [[Parameter: MTP2 T3 Timer|T3 Timer]] |
| − | * [[Parameter: T5 Timer|T5 Timer]] | + | * [[Parameter: MTP2 T5 Timer|T5 Timer]] |
| − | * [[Parameter: T6 Timer|T6 Timer]] | + | * [[Parameter: MTP2 T6 Timer|T6 Timer]] |
| − | * [[Parameter: T7 Timer|T7 Timer]] | + | * [[Parameter: MTP2 T7 Timer|T7 Timer]] |
|} | |} | ||
</div> | </div> | ||
Revision as of 11:31, 1 September 2015
Applies to version(s): v2.8
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the navigation panel.
2- Click Create New Mtp2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Select the type of Error Correction to use.
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
List of Parameters
Lives States
