Toolpack:Creating an ISUP User Part B
(→List of Parameters) |
(→List of Parameters) |
||
| Line 56: | Line 56: | ||
* [[Parameter: IsupUserPart_T1 Timer|T1 Timer]] | * [[Parameter: IsupUserPart_T1 Timer|T1 Timer]] | ||
* [[Parameter: IsupUserPart_T2 Timer|T2 Timer]] | * [[Parameter: IsupUserPart_T2 Timer|T2 Timer]] | ||
| − | * [[Parameter: IsupUserPart_T5 Timer| | + | * [[Parameter: IsupUserPart_T5 Timer|T5 Timer]] |
* [[Parameter: IsupUserPart_T6 Timer|T6 Timer]] | * [[Parameter: IsupUserPart_T6 Timer|T6 Timer]] | ||
* [[Parameter: IsupUserPart_T7 Timer|T7 Timer]] | * [[Parameter: IsupUserPart_T7 Timer|T7 Timer]] | ||
Latest revision as of 10:57, 17 September 2015
Applies to version(s): v2.8.
Once you have created your ISUP network, you must create a new ISUP user part.
The user part is the container for the multiple ISUP interfaces. One user part is required for each protocol variant. A user part can be seen as a protocol variant that a host application wants to use on the SS7 network.
Multiple ISUP user parts can be instantiated within a single ISUP protocol layer. This allows a user application to interface with multiple SS7 ISUP protocol variants at the same time. In addition, only one ISUP user part is required for a specific variant as it can be assigned to multiple ISUP networks.
To create an ISUP user part:
1- Click ISUP in the navigation panel.
2- Select the ISUP stack
3- Click Create New Isup Userpart in the ISUP stack configuration window:
4- Configure the new ISUP user part:
- Enter a name for the user part
- Select a protocol variant (depending on location)
- Select an MTP3 sub service field (the same that was previously set for MTP3)
- Select an address indicator type
- Select a Numbering Plan
- Click Create
5- Verify that the "IsupUserpart was successfully created" message appears
List of Parameters
- Name
- Protocol Variant
- MTP3 Sub Service field
- Default Nature of Address When Unspecified
- Default Numbering Plan When Unspecified
