Toolpack:Creating an M3UA SAP (IPSP) B
From TBwiki
(Difference between revisions)
m (moved Toolpack:Creating an M3UA SAP B to Toolpack:Creating an M3UA SAP (IPSP) B: Consistency) |
(→List of Parameters: Added SAP and Advanced timers links) |
||
| Line 42: | Line 42: | ||
* [[Parameter: SCTP Adapter|SCTP Adapter]] | * [[Parameter: SCTP Adapter|SCTP Adapter]] | ||
* [[Parameter: SCTP Source Port|SCTP Source Port]] | * [[Parameter: SCTP Source Port|SCTP Source Port]] | ||
| + | |||
| + | '''M3UA SAP Timers''' | ||
| + | * [[Parameter: SCTP Primitive Timer|SCTP Primitive Timer]] | ||
| + | * [[Parameter: SCTP Association Timer|SCTP Association Timer]] | ||
| + | |||
| + | '''SCTP SAP Advanced Parameters''' | ||
| + | * [[Parameter: Maximum data size|Maximum data size]] | ||
Revision as of 10:59, 28 September 2015
Applies to version(s): v2.8
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click M3UA in the navigation panel:
2- Click Create New M3ua Sap in the M3UA configuration panel
3- Configure the new SAP:
- Enter a name for the SAP
- Select an Unit to use
- Select an SCTP source port
- Click Create
4- Verify that the "M3ua Sap was successfully created" message appears
5- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
List of Parameters
M3UA SAP Timers
SCTP SAP Advanced Parameters
