Toolpack:Creating an M3UA SAP (IPSP) B
From TBwiki
(Difference between revisions)
(→List of Parameters: Added SAP and Advanced timers links) |
(→List of Parameters) |
||
| Line 49: | Line 49: | ||
'''SCTP SAP Advanced Parameters''' | '''SCTP SAP Advanced Parameters''' | ||
* [[Parameter: Maximum data size|Maximum data size]] | * [[Parameter: Maximum data size|Maximum data size]] | ||
| + | * [[Parameter: Maximum ACK delay|Maximum ACK delay]] | ||
| + | * [[Parameter: Maximum datagram before ACK|Maximum datagram before ACK]] | ||
| + | * [[Parameter: Initial Retransmission Timeout (RTO)|Initial Retransmission Timeout (RTO)]] | ||
| + | * [[Parameter: Minimum Retransmission Timeout (RTO)|Minimum Retransmission Timeout (RTO)]] | ||
| + | * [[Parameter: Maximum Retransmission Timeout (RTO)|Maximum Retransmission Timeout (RTO)]] | ||
| + | * [[Parameter: Freeze timer|Freeze timer]] | ||
| + | * [[Parameter: Bundle timer|Bundle timer]] | ||
| + | * [[Parameter: Cookie life time|Cookie life time]] | ||
| + | * [[Parameter: Delay between heartbeat|Delay between heartbeat]] | ||
| + | * [[Parameter: Maximum datagram burst|Maximum datagram burst]] | ||
| + | * [[Parameter: Maximum heartbeat at each RTO|Maximum heartbeat at each RTO]] | ||
| + | * [[Parameter: Shutdown Guard Timer|Shutdown Guard Timer]] | ||
| + | * [[Parameter: Handle INIT datagram|Handle INIT datagram]] | ||
| + | * [[Parameter: Abort negociation if nb. streams mismatch|Abort negociation if nb. streams mismatch]] | ||
| + | * [[Parameter: Flow-control up threshold|Flow-control up threshold]] | ||
| + | * [[Parameter: Flow-control down threshold|Flow-control down threshold]] | ||
Revision as of 11:04, 28 September 2015
Applies to version(s): v2.8
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click M3UA in the navigation panel:
2- Click Create New M3ua Sap in the M3UA configuration panel
3- Configure the new SAP:
- Enter a name for the SAP
- Select an Unit to use
- Select an SCTP source port
- Click Create
4- Verify that the "M3ua Sap was successfully created" message appears
5- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
List of Parameters
M3UA SAP Timers
SCTP SAP Advanced Parameters
- Maximum data size
- Maximum ACK delay
- Maximum datagram before ACK
- Initial Retransmission Timeout (RTO)
- Minimum Retransmission Timeout (RTO)
- Maximum Retransmission Timeout (RTO)
- Freeze timer
- Bundle timer
- Cookie life time
- Delay between heartbeat
- Maximum datagram burst
- Maximum heartbeat at each RTO
- Shutdown Guard Timer
- Handle INIT datagram
- Abort negociation if nb. streams mismatch
- Flow-control up threshold
- Flow-control down threshold
