Toolpack:Creating a Line Interface D
From TBwiki
(Difference between revisions)
(Added Northbound Interface content) |
|||
| Line 84: | Line 84: | ||
</pre> | </pre> | ||
</div> | </div> | ||
| + | |||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 10:34, 9 December 2015
Applies to version(s): v2.9.
Line interface is a generic term for TDM physical interfaces. TelcoBridges products support 3 types of physical interfaces:
To create a new line interface:
1- Select TDM Line Interfaces from the navigation panel
2- Click Create New Line Interface to create a single interface ,or Create Multiple Line Interfaces to create many interfaces at once
3- Create the new line interface:
- Enter a name for the interface
- Set a type for the interface
- Set a local index for the line
- Select a length and an encoding scheme
- Click Create
4- Verify that the "Line interface was successfully created" message is displayed
Path
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/tdm_line_interfaces/@[line_interface_name]
Parameters (text)
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/tdm_line_interfaces/@[line_interface_name] local_index = 0 name = "@[line_interface_name]" type = "T1" /configurations/@[configuration_name]/hardware_units/@[hardware_name]/tdm_line_interfaces/@[line_interface_name]/state loopback_type = "None" tx_state = "TX on" /configurations/@[configuration_name]/hardware_units/@[hardware_name]/tdm_line_interfaces/@[line_interface_name]/t1_parameters encoding = "B8ZS" length = "Short" signal_level = "2"
Parameters (json)
{
"local_index" : 0,
"name" : "LI_T1_00",
"state" : {
"loopback_type" : "None",
"tx_state" : "TX on"
},
"t1_parameters" : {
"encoding" : "B8ZS",
"length" : "Short",
"signal_level" : "2"
},
"type" : "T1",
"line_services" : {
}
}
List of Parameters
Advanced Parameters
