Factory Reset
From TBwiki
(Difference between revisions)
(New page) |
(Updated page) |
||
| Line 1: | Line 1: | ||
| − | The Factory reset button is located in a small hole at the right of the shutdown button. | + | This function is available on TMG800 units shipped since October 2015 <br> |
| − | Use a trombone to press the button on the front. | + | The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges]. <br> |
| − | Keep the button pressed until the LEDs become red, then release it. Wait from 2 to 5 minutes to access the system. | + | After this procedure, you may have to install a new software version on the unit - see [[Toolpack_version_history|Version History]]. <br> |
| + | The Factory reset button is located in a small hole at the right of the shutdown button. Use a trombone to press the button on the front. <br> | ||
| + | Keep the button pressed until the LEDs become red, then release it (about 10 seconds). Wait from 2 to 5 minutes to access the system. <br> | ||
| + | Please follow the [[Product_Installation|installation guide]] for information on how to access the system. <br> | ||
Revision as of 09:45, 27 October 2016
This function is available on TMG800 units shipped since October 2015
The Factory reset function will put the unit in the same state as when it was shipped from TelcoBridges.
After this procedure, you may have to install a new software version on the unit - see Version History.
The Factory reset button is located in a small hole at the right of the shutdown button. Use a trombone to press the button on the front.
Keep the button pressed until the LEDs become red, then release it (about 10 seconds). Wait from 2 to 5 minutes to access the system.
Please follow the installation guide for information on how to access the system.
