Factory Reset
(Updated page) |
(LM Added details on procedure (trk#19758)) |
||
| Line 1: | Line 1: | ||
| − | This function is available on TMG800 units shipped since October 2015 <br> | + | === '''''Applies to version(s): v2.9, v2.10''''' === |
| − | The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges]. <br> | + | {{DISPLAYTITLE:Factory Reset}} |
| − | After this procedure, you may have to install a new software version on the unit | + | |
| − | The Factory reset button is located in a small hole at the right of the shutdown button. Use a trombone to press the button on the front. | + | This function is available on '''TMG800''' units shipped since October 2015 <br> |
| − | Keep the button pressed until the LEDs become red, then release it | + | The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges], including the software version. <br> |
| + | After this procedure, there will be no configuration on the unit. The unit will have the default password: Please contact [[TB_Support|Support]] if you do not have this password. <br> | ||
| + | You may have to install a new software version on the unit (see [[Toolpack_version_history|Version History]] and [[System_Upgrade|System upgrade]] ).<br> | ||
| + | <br> | ||
| + | |||
| + | The Factory reset button is located in a small hole at the right of the shutdown button.<br> | ||
| + | [[File:TMG800_Reset_button.bmp]]<br> | ||
| + | Use a trombone to press the button on the front. Keep the button pressed for '''10 seconds''' until the LEDs become red, then release it. Wait from '''2 to 5 minutes''' to access the system. <br> | ||
| + | <br> | ||
Please follow the [[Product_Installation|installation guide]] for information on how to access the system. <br> | Please follow the [[Product_Installation|installation guide]] for information on how to access the system. <br> | ||
| + | Once the system is accessible, you can recover a database backup that was previously generated (see [[Toolpack:Restoring_a_Database_Backup_C|Restoring a database backup]]) <br> | ||
Revision as of 14:41, 4 April 2017
Applies to version(s): v2.9, v2.10
This function is available on TMG800 units shipped since October 2015
The Factory reset function will put the unit in the same state as when it was shipped from TelcoBridges, including the software version.
After this procedure, there will be no configuration on the unit. The unit will have the default password: Please contact Support if you do not have this password.
You may have to install a new software version on the unit (see Version History and System upgrade ).
The Factory reset button is located in a small hole at the right of the shutdown button.
Use a trombone to press the button on the front. Keep the button pressed for 10 seconds until the LEDs become red, then release it. Wait from 2 to 5 minutes to access the system.
Please follow the installation guide for information on how to access the system.
Once the system is accessible, you can recover a database backup that was previously generated (see Restoring a database backup)
