Toolpack:Creating a SIP Domain SBC A

Revision as of 15:15, 26 July 2017

Applies to version(s): v3.0

A SIP domain represents a grouping of devices (or users) that can communicate with one another. You must configure SIP Registration Domain for your system. The first step in doing so is to create a SIP Domain:

1- Click SIP Domain in the navigation panel

2- Click Create New Domain

3- Create the new Domain:

• Enter a configuration Name for this domain.
• Enter a Domain Name for the SIP Registration Domain (domain can be a FQDN or an IP address)
• Set the number 'Maximum Registered Users' for this domain
• Set the Expires value used by SBC when the remote device doesn't supply one (Default Contact Expire)
• Select Routing Method the system will use to route calls to registered users (if enabled in routing scripts).
  • Register source: Sends SIP Invite to the registering source IP address.
  • Contact: Sends SIP Invite to the 'contact' from the Register message.
• Set 'Default Contact Expiration' value when not supplied by the user agent.
• Set the 'Minimum Contact Expiration' Expires value accepted. Lower values will be rejected with a 423 'Interval too brief' response.
• Set 'Maximum Contact Expiration' Expires value accepted. Higher value are replaced by this parameter.
• Forwarding Parameters:
  • Select the Registration Forwarding Mode to the registrar:
    • Contact Remapping: Changes the user and the IP address.
    • Contact Passthrough: Doesn't change anything. Enables devices to be contacted directly without going through the SBC.
  • Set the minimum 'Expires' value sent to the registrar.
  • Set the maximum Pending Register Forward: Maximum simultaneous pending register requests allowed for this domain.
  • Set the simultaneous Register Forward: Maximum simultaneous active register requests allowed for this domain.
• Click Create

4- Verify that the Sip registration domain was successfully created message appears