Toolpack:Modifying ISUP Userpart for SPIROU B

Revision as of 14:13, 11 December 2017

Applies to version(s): v2.8, v2.9, v2.10, v3.0

This article assumes that SS7 ISUP is configured'.

1- Select ISUP from the navigation panel

2- Select the ISUP stack you wishto configure.

3- In the Editing Userparts section, select the ISUP userpart you to configure.

4- Select SPIROU in the Protocol Variant drop-down menu.

5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.

• Select this checkbox to make sure your configuraton is compliant with SPIROU.

6- Click Timers to expand the Timers section

• Set T6 Timer to a value between 60000 and 120000 ms (between 60 and 120 seconds)

7- Click Advanced Parameters to expand the Advanced Parameters section

• Uncheck the Allow group messages option
• Click Save

8- Verify that the "IsupUserpart was successfully updated" message is displayed

List of Parameters

• Name
• Protocol Variant
• MTP3 Sub Service field
• Default Nature of Address When Unspecified
• Default Numbering Plan When Unspecified