Toolpack:Creating an SCCP LSAP C
From TBwiki
(Difference between revisions)
m |
m |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2.9, | + | === '''''Applies to version(s): v2.9, v2.10, v3.0''''' === |
{{DISPLAYTITLE:Creating an SCCP LSAP}} | {{DISPLAYTITLE:Creating an SCCP LSAP}} | ||
After you create an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | After you create an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | ||
Revision as of 10:46, 20 December 2017
Applies to version(s): v2.9, v2.10, v3.0
After you create an SCCP network, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Select SCCP from the navigation panel
2- Select an SCCP Network
3- Click Create New SCCP LSAP in the SCCP network configuration window
4- Configure the new SCCP LSAP:
- Enter a Name for the LSAP
- Click Create
5- Verify that the "SccpLsap was successfully created" message appears
Path
/configurations/@[configuration_name]/sccp_stacks/@[sccp_stack]/sccp_networks/@[sccp_network]/sccp_lsaps/@[sccp_lsap]
Parameters (text)
/configurations/@[configuration_name]/sccp_stacks/@[sccp_stack]/sccp_networks/@[sccp_network]/sccp_lsaps/@[sccp_lsap] max_msg_len = 272 name = "@[sccp_lsap]"
Parameters (json)
{
"max_msg_len" : 272,
"name" : "@[sccp_lsap]",
}
List of Parameters
Advanced Parameters
