Toolpack:Adding a Transcoding Unit A

Revision as of 08:51, 1 August 2018

Applies to version v3.0

To add a transcoding unit:

1- Click Hardware Units in the navigation panel

2- Click Create New Unit, to add a new hardware device

3- Enter information for the following parameters:

• Enter a name for the hardware device
• Enter the serial number of the new hardware device (filling in the Serial Number field will cause auto-completion of the field to occur).
• Select TDM and/or IP from the Type field.
• Enter the location in which the hardware device is installed.
• Enter a meaningful description about the use or purpose of the hardware device.
• Select Enabled from the Target State field.
• Select the type of TDM lines that the hardware device will support.
• Leave the Is N+1 Backup field empty.
• Provide the amount of time in seconds, that the system will wait for calls to complete before shutting down for an upgrade.
• Click Create

4- Verify that the Unit was successfully created message appears, and that the newly added hardware device appears in the Hardware List.

List of Parameters

• Name
• Serial Number
• Type
• Location
• Description
• Target State
• TDM Lines Type
• Is N+1 Backup
• Graceful Upgrade Timeout